欢迎您~Power supply form the basic building block of any electronic circuits and therefore its important to familiarize the DC power supply circuit construction.The above given circuit illustrates a simple approach to construct a dual DC power supply of 5V and 12V from the 230V AC mains supply.欢迎您~The Voltage ranges 5V and 12V are widely used in all kinds of simple electronic circuits, so its meaningful to learn this simple construction.
WORKING OF DUAL POWER SUPPLY CIRCUIT:
The above circuit obtains power from a 230V AC mains supply voltage and fed into a step down transformer for transforming higher voltage supply to lower one.The transformer TR1 can be of 230V primary ,15V secondary and 1A step down transformer.The stepped down voltage can be fed into the bridge rectifier made of four 1N4004 diodes for the conversion of AC supply to DC one.
IC regulator pinout
The output from the bridge rectifier was filtered by the capacitor C1 and C2 to offer a steady DC level to the input pins of the regulators used in the above circuit.The DC voltage is then fed in to the IC 7805 which is a 5V regulator and also to the IC 7812 which was a 12V regulator.The output obtained from the 7805 & 7012 are 5V and 12V respectively.A LED D5 was connected through the current limiting resistor R1 for indicate the state of the device.
This kind of circuits are highly useful where two dual range of DC voltages are used to power the operation of a circuit.Varying the voltage regulator IC ‘s 7805 or 7812 with 7806 and 7808 to obtain 6V and 8V as output.But each IC have minimum and maximum voltage requirements, so make sure you build in such a way to meet the requirements.
Thank you for this circuit.I'll be testing it in the lab.
One mistake that you've made in your PCB layout is of the power source terminals.The negative terminal is not connected correctly.It should be between diodes 2 and 4.
Hi Frank,
I am looking to connect esp32 and 12v led array with this circuit, will it work ?
Thank you for this circuit.I'll be testing it in the lab.
One mistake that you've made in your PCB layout is of the power source terminals.The negative terminal is not connected correctly.It should be between diodes 2 and 4.
Thanks for pointing it out
is it provide 1A
What if I use a step down transformer 220v – 12v 2amphere.What will be the effect if I use that components?Thanks